Table of Contents
Advertisement
correcting outfeed table parallelism
this procedure involves turning the table stop
bolts to raise or lower the front of the tables until
they are parallel with the cutterhead.
to correct outfeed table parallelism:
1.
loosen the lock nuts on both stop bolts
shown in figure 69 at the front of the table.
lock nuts
stop Bolts
figure 69. location of outfeed table stop bolts
and lock nuts.
2.
raise the stop bolts just enough so the
front edge of the table is higher than the
cutterhead, then adjust each stop bolt
clockwise to gradually lower the table.
3.
Check the outfeed table height again (see
steps 3-5 on page 51).
4.
Continue lowering the bolts and checking
until the outfeed table height above the
cutterhead is equal across the table.
checking infeed table parallelism
1.
Follow all the steps for checking the outfeed
table parallelism to first make sure that the
outfeed table is parallel with the cutterhead.
2.
place the straightedge halfway across the
infeed table and halfway over the outfeed
table, and adjust the infeed table even with
the outfeed table, as shown in figure 70.
-52-
Outfeed Table
figure 70. infeed and outfeed tables set parallel.
— if an insert touches the straightedge,
turn the cutterhead so the inserts do not
interfere.
— if the cutterhead touches the straightedge,
raise the outfeed table higher than the
cutterhead.
3.
place the straightedge in the positions shown
in figure 71. in each position, the straight-
edge should sit flat against both the outfeed
table and the infeed table.
Black Lines Represent
Straightedge Positions
from Overhead View
⁄
-turn
1
6
figure 71. straightedge positions for checking
infeed/outfeed table parallelism.
— if the straightedge sits flat against both
the infeed and outfeed table, then the
tables are parallel. set the outfeed table
height and replace the cutterhead guard
(page 24).
— if the straightedge does not sit flat against
both the infeed and outfeed table in any
of the positions, then follow the adjusting
table parallelism instructions.
Model G0634Z/G0634XP (Mfd. Since 01/11)
Straightedge
Infeed Table
Advertisement
Table of Contents
