Inventory - Grizzly G0634XP Owner's Manual

the following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
if any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
B
e
F
box 1 (figure 3)
a. Jointer/planer assembly (not shown) ........ 1
b. push Blocks ................................................ 2
c. Cutterhead guard assembly ...................... 1
d. hex wrenches 3, 4 mm, 3/32" ............1 ea.
e. t-handle wrench
1
Model G0634Z/G0634XP (Mfd. Since 01/11)

inventory

C
figure 15. loose inventory.
Qty
/ " .................................. 1
4
NOTICE
if you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
g
box 1 (figure 3) ........................................... Qty
f. torx drivers t25 ......................................... 5
g. open-end wrenches 8/10, 12/14mm ..1 ea.
h. Carbide inserts 15 x 15 x 2.5mm ............... 5
i. Flat hd torx screws 10-32 x
d
h
i
⁄ " t25 ....... 10
1
2
-19-