Table of Contents
Advertisement
section 6: maintenance
to reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
schedule
For optimum performance from this machine, this
maintenance schedule must be strictly followed.
ongoing
to maintain a low risk of injury and proper
machine operation, if you ever observe any of the
items below, shut down the machine immediately
and fix the problem before continuing operations:
•
vacuum all dust on and around the machine.
•
wipe down tables and all other unpainted
cast-iron with a metal protectant.
•
Check for/repair worn or damaged wires.
•
Check/resolve any other unsafe condition.
•
Check/tighten loose mounting hardware.
•
Check/replace damaged cutterhead knives/
inserts.
Weekly
•
Clean cutterhead.
monthly
•
Check belt for proper tension, damage, or
wear/replace belt.
•
Clean/vacuum dust buildup from inside cabi-
net and off motor.
•
lubricate worm gear
•
lubricate roller chains
•
lubricate elevation lead screw
•
lubricate worm shaft
Model G0634Z/G0634XP (Mfd. Since 01/11)
cleaning &
protecting
Cleaning the model g0634z/g0634Xp is relative-
ly easy. vacuum excess wood chips and sawdust,
and wipe off the remaining dust with a dry cloth.
if any resin has built up, use a resin dissolving
cleaner to remove it.
protect unpainted cast-iron tables by wiping them
clean after every use—this ensures moisture
from wood dust does not remain on bare metal
surfaces. keep the tables rust-free with regular
applications of products like g96
slipit
, or Boeshield
®
®
details).
lubrication
NOTICE
failure to follow reasonable lubrication
practices as instructed in this manual for
your machine could lead to premature fail-
ure of components and void the warranty.
this machine features bearings that are lubricated
and sealed at the factory. these bearings do not
require any further attention unless they need to
be replaced. if a bearing fails, your machine will
probably develop a noticeable rumble or vibration,
which will increase when the machine is under a
load. the bearings are standard sizes and can be
replaced through grizzly.
Follow the procedures in this section to properly
lubricate the other components, essential for long
life and trouble-free operation of your machine.
gun treatment,
®
t-9 (see page 41 for more
-43-
Advertisement
Table of Contents
