Base Reference Point - SATO CL412E Operator And Technical Reference Manual

Command Structure
Command Function
Input to Printer:
Printer Output:
SATO CL Series "e" Printers

Base Reference Point

<ESC>A3H-aaaa-Vbbbb
- = This character is optional. When present, it specifies that
the horizontal offset is in the negative direction. If it is left
out the offset direction is positive.
aaaa = Horizontal Print Offset (see Note 7 for field range)
bbbb = Vertical Print Offset (see Note 7 for field range)
Example: <ESC>A3H100V0050
Placement: Preceding all images that are based on the new base
reference point
Default: Current V and H offset setting
To establish a new base reference point for the current label. The
base reference point is the top left corner or "origin" from where all
print position commands are based.
This command may be very helpful when using labels less than four
inches wide to place images on the printable label surface. It may also
be used to move images past preprinted fields on a label.
A3H0300V0075
PN 9001074 Preliminary
Section 5. Programming Reference
Page 5-19