Command Default Settings; Darkness - SATO CL412E Operator And Technical Reference Manual

COMMAND DEFAULT SETTINGS

There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a "default" value
is assumed. The commands and the corresponding default values are:
COMMAND
Print Rotation
Vertical Reference Point
Horizontal Reference Point
Character Pitch
Base Reference Point
Character Expansion
Print Darkness
Print Speed CL6XX
Print Speed CL4XX
Proportional Spacing
Cutter Command
NOTES:
(1) The settings for these commands will revert to the default value when the printer
receives an <ESC>Z or an <ESC>*.
(2) The values transmitted with these commands will remain in effect until a new
command is received.
SATO CL Series"e" Printers
Base H=20
Ref
Point
V=800
"%1"
DEFAULT
0°
0
0
2
H=0, V=0
1
2
6 ips
4 ips
Enabled
Disabled
PN 9001074 Preliminary
Section 5. Programming Reference
Label
Feed
Direction
NOTE
(1)
(1)
(1)
(1)
(2)
(1)
(1)
(2)
(2)
(1)
(1)
Page 5-9