SATO CL412E Operator And Technical Reference Manual page 241

INSTRUCTION DESCRIPTION
Printer Configuration Commands
I2abcde Serial Interface. Sets the operating parameters for the Serial RS232
interface. Sets the default printer configuration in Flash ROM. See
Serial Interface Parameters command in the Configuration Commands
of Section 5: Programming Reference of this manual for details.
IGa Sensor Type. Selects the sensor type.
a
LD,a,b,c,d,e, Download Protocol Command Codes. Downloads a user defined set
f,g,i, j j of Alternate Protocol Command Codes. See Appendix E for details on
the proper usage of this command.
PCaa,bb Printer Setting. Sets the default printer configuration in Flash ROM.
PCF,a,.....z See Printer Setting command in the Configuration Commands of
Section 5: Programming Reference of this manual for details.
PHa Print Type. Selects the thermal printing method.
a
PMa Print Mode. Selects desired backfeed operation.
a
POabcc Pitch Offset. Sets the pitch type, direction and offset to be used
a
b
cc
SATO CL Series "e" Printers
= 0 Reflective (Eye-Mark) sensor.
1 Transmissive (See-Thru) sensor
2 Sensor not used
= 0 Thermal transfer printing
1 Direct thermal printing
= 0 No backfeed, continuous operation
1 Tear-Off
2 Cut, backfeed after print
3 Cut, backfeed before print
4 Cut, no backfeed
7 Dispense, backfeed after print
8 Dispense, backfeed before print
= 0 Cutter
1 Dispense
2 Tear-Off
3 Continuous
= + Positive offset
- Negative offset
= 00 to 99, offset value in dots.
PN 9001074 Preliminary
Appendix A: Command Quick Reference
PAGE
Page 5-
Page 5-
Page 5-
Page 5-
Page 5-
Page 5-
Page 5-
Page A-13