SATO CL412E Operator And Technical Reference Manual page 224

Section 7. Troubleshooting
TCP/IP Troubleshooting
If you are using TCP/IP and cannot print to the print server and you have checked the
hardware and network as described in the previous steps, then check the following
(note that it is always a good idea to try creating a another print queue to eliminate the
possibility of setup errors):
l. The problem may be the result of mismatched or duplicate IP addresses.
Verify that the IP address is correctly loaded into the XCD print server (via
the self-test page or through the remote console) and make sure that no
other nodes on the network have this address (DUPLICATE IP ADDRESSES
ARE THE BIGGEST CAUSE OF TCP/IP PRINTING PROBLEMS). If the
address is not correct, then check whether the loading procedure was
properly executed.
2. If you used NCP, XCONFIG, or ccr to enter the IP address, make sure that
you exited the remote console properly with a CTRL-D or EXIT command.
3. If you used rarp, make sure that you started the rarp daemon using the
rarpd, rarpd -a, in.rarpd -a, or equivalent command. Verify that the
/etc/ethers file contains the correct Ethernet address and that the print
server name matches the name in the /etc/hosts file.
4. If you used bootp, make sure that bootp is enabled (i.e., the "#" is
removed from the bootp entry) in the
/etc/inetd.conf file. Verify that /etc/bootptab file is correctly configured.
5. Also verify that the host computer and the print server are either on the
same subnet (for example, if the print server has a subnet mask of
255.255.255.0, the host must have the same subnet mask) or that the
router is properly configured to pass data between the two devices.
6. Make sure that the /etc/printcap file (if applicable) is typed in correctly.
In particular, look for missing ":" and "\" characters, because a small error
anywhere in the file can have major consequences. Also check the
/usr/spool directory to make sure that you have created a valid spool
directory.
7. If you are using a Berkeley-based UNIX, make sure that the daemon is
started on Berkeley based systems with the command lpc start printer,
where printer is the name of the local print queue.
8. If you are using an AT&T-based UNIX, make sure the printer is enabled
(enable printer, where printer is the name of the local print queue).
9. Make sure that the lpr/lpd remote line printer service are running on the
host computer (refer to your host computer documentation for
information on how to do this).
10. If you cannot print from DEC TCP/IP Services for VMS (UCX), make sure
that you have version 2.0B or later of this software, because earlier
versions will not work with the print servers.
Page 7-6 PN 9001074 Preliminary SATO CL Series "e" Printers