Table of Contents
Advertisement
CDD-562AL/564A/L Multi-Channel Demodulator
Telnet and CLI Operation
•
Set this option to [Enabled] or [Disabled] for each Rx Channel:
[Enabled] – enables Header Decompression
o
[Disabled] – disables Header Decompression
o
•
When Enabled, the system expects received streams to be Header-compressed.
•
Note: A CDM-IP modem (or demodulator) must receive all streams as compressed, or as not
compressed. The unit cannot distinguish between the two types.
Rx Payload Decompression, keystroke: C
•
Switches between [Enabled] or [Disabled]:
•
Causes a unit receiving a stream of data that has been payload compressed to be correctly
uncompressed. This option is auto-sensed by a bit carried in packet headers.
FAST Feature Code 1 or 2, keystroke: 1 or 2
•
Allows entry of a FAST Option Purchase Access Code; purchase a specific option/upgrade to
receive an applicable code from the Comtech EF Data Sales Representative.
Vipersat Feature Codes, keystroke: F
•
Allows user to enter a Vipersat features activation code that has been provided by Comtech
Vipersat for modems (or demodulators) configured to operate under VMS control.
Vipersat Management, keystroke: V
•
For details on configuration and use of the CDD-56xAL Vipersat feature, see Comtech EF Data
publication MN/22137 – Vipersat CDD-56xAL Series Satellite Network Demodulator Router
User Guide.
Vipersat File Streamer, keystroke: R
LAN-to-LAN Routing, keystroke: B
•
When LAN-to-LAN Routing is enabled, packets ingress from LAN can be routed (egress) to the
LAN port instead of sending the ICMP redirect message. If selected, this prompt shows:
"Configuring LAN-to-LAN Routing disables the ICMP redirect Messages. Do you want
o
to continue(Y/N)[Enter :No]"
9–11
Revision 0
MN-CDD562AL564AL
Advertisement
Table of Contents
