Chapter 7. Ethernet-Based Remote Product Management; Introduction; Ethernet Management Interface Protocols; Simple Network Management Protocol (Snmp) - Comtech EF Data CDD-562AL Installation And Operation Manual

CDD-562AL/564A/L Multi-Channel Demodulator
Ethernet-based Remote Product Management
Chapter 7. ETHERNET-BASED
7.1

Introduction

Ethernet-based Remote Product Management of the CDD-56xA/L Multi-Channel Demodulator is
available using the rear panel RJ-45 10/100 BaseT Ethernet Traffic/M&C port.
The M&C port is available only when Dedicated Management Port operation is enabled.
7.2

Ethernet Management Interface Protocols

A user-supplied PC is required for Ethernet-based remote monitor and control (M&C) of the
CDD-56xA/L. Three separately-operated protocols are available:
•

Simple Network Management Protocol (SNMP)

•

Telnet Interface

•

HTTP Web Server Interface

7.2.1 Simple Network Management Protocol (SNMP)
SNMP requires these user-supplied items:
•
Network Management System (NMS)
•
Management Information Base (MIB) File Browser
7.2.2 Telnet Interface
Telnet requires these user-supplied items:
•
User PC
•
Command-Line Interface (CLI)
•
Terminal emulation program installed on the user PC
7.2.3 HTTP Web Server Interface
The Web Server Interface requires these user-supplied items:
•
User PC
REMOTE PRODUCT
MANAGEMENT
7–1
Revision 0
MN-CDD562AL564AL