Table of Contents
Advertisement
CDD-562AL/564A/L Multi-Channel Demodulator
Quick Start Guide
Chapter 8. QUICK START GUIDE
8.1
Introduction
To use this chapter, you must be familiar with the configuration and operation of both the CDM-IP
modem and the CDD-564A/L demodulator.
Use this chapter to quickly configure a pair of Comtech EF Data IP-compatible modems using a
CDD-564A/L as the demodulator. Hereafter, these modems are called the CDM-IP modems.
Follow this Quick Start Guide, begin with the factory default settings, and you can cause the system to
pass traffic within minutes.
8.2
Equipment List
•
CDM-IP modems, quantity 2
CDM-570
o
CDM-570/A-IP
o
CDM-570L
o
CDM-570A/L-IP
o
•
CDD-564A/L Demodulator, quantity 1
Depending on the modems used, you might need to provide equipment to convert 70
o
MHz IF to L-Band for a duplex connection.
•
10/100 BaseT Ethernet Hub, quantity 2
User provided
o
Only 10BaseT operation is supported in Managed Switch Mode (formerly easyConnect
o
Mode).
RJ-45 crossover Ethernet cables can be substituted to connect PC to CDM-IP modem
o
directly, without using a hub.
•
PC with network interface card and terminal emulation program, quantity 2
User provided
o
Examples are: PuTTY, Tera Term, etc.
o
•
Console cable, quantity 1
Comtech EF Data provided
o
DB-9 to RJ-11
o
•
CAT5 Ethernet cables, quantity 4
User provided
o
•
IF cables, quantity 2
User provided
o
Connects Tx/Rx between both CDM-IP modems
o
Type BNC for 70/140 MHz operation
o
Type N for L-Band operation
o
8–1
Revision 0
MN-CDD562AL564AL
Advertisement
Table of Contents
