Loading A Pipe Spec In Pipespec Designer - Siemens COMOS Operating Manual

Loading a pipe spec in PipeSpec Designer

Requirement
● A pipe spec has already been created.
● The "Pipe spec administration" tab of the PipeSpec Designer is open. See also chapter
Calling the PipeSpec Designer (Page 69).
Procedure
1. On the "Pipe spec administration" tab, click the "..." button next to the "Pipe spec" field.
The "Load pipe spec" window will open.
The "Load pipe spec" window contains one or two tabs for further editing.
2. If you are working in one engineering project, choose a tab in the "Load pipe spec" window:
– To load a pipe spec that was created in an engineering project, select the "Engineering
– To load a basic class/system class, select the "Base project" tab.
If you are working in the base project, only the "Current project" tab is available to you. It
shows the basic classes/system classes.
3. To load a previously created pipe spec, select the desired pipe spec in the structure tree.
4. Confirm your entries.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
project" tab.
Note
Pipe specs that are created in the base project are read-only in the engineering project.
5
71