Configuring The "Characteristics" Tab; Defining The Fluid Characteristics Of The Spec; Defining The Fluid Group According To The Dgrl - Siemens COMOS Operating Manual

Configuring pipe specs

8.3 Configuring the "Characteristics" tab

4. In the "Column in catalog" list, select the column of the geometry table from which the
dimension value is to be read.
5. Save your entries.
Result
The values are read from the geometry table and written to the nominal-diameter-dependent
characteristics table on the "Characteristics" tab.
8.3 Configuring the "Characteristics" tab
Here you define additional characteristics of the pipe spec. For example, define which nominal-
diameter-dependent characteristics the pipe spec gives.
8.3.1

Defining the fluid characteristics of the spec

Requirement
● Observing the workflow for configuration of pipe specs. See also chapter Overview for
configuring pipe specs (Page 79).
● You have opened the "Characteristics" tab.
● You are working in the "Class fluid parameters" control group.
Procedure
1. Select the "Fluid type", the "Fluid key", and the "Flow medium" of the pipe spec.
2. Save your entries.
8.3.2

Defining the fluid group according to the DGRL

Requirement
● Observing the workflow for configuration of pipe specs. See also chapter Overview for
configuring pipe specs (Page 79).
● You have opened the "Characteristics" tab.
● You are working in the "Fluid group acc. to DGRL" control group ("DLRG" = pressure
equipment directive). This control group is used for pipe spec documentation.
84
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA