Loading And Activating Commissioning File - Siemens SINUMERIK 840D sl Commissioning Manual

Tool management

5.5 Loading and activating commissioning file

N3950 $TC_MPP3[9999,1]=0; Consider adjacent location off! N3960
$TC_MPP4[9999,1]=2; Location status: Unassigned
iN3970 $TC_MPP5[9999,1]=1; Location type index
N3980 ;
N3990 $TC_MPP1[9999,2]=7
N4000 $TC_MPP2[9999,2]=0
N4010 $TC_MPP3[9999,2]=0
N4020 $TC_MPP4[9999,2]=2
N4030 $TC_MPP5[9999,2]=2
N4040 ;
N4650 ; Offsets (clearances) ; Clearances to magazine
N4660 ;
N4670 $TC_MDP2[1,1]=0 ; Spindle
N4680 $TC_MDP2[1,2]=0 ; Gripper 1
N4690 $TC_MDP2[1,3]=0 ; Gripper 2
N4700 $TC_MDP1[1,1]=0 ; 1st loading point
N4710 $TC_MDP1[1,2]=25 ; 2nd loading point (clearance 25 to actual
position)
N4720 ;
N4730 ; End
N4740 ;
N4750 M30
5.5 Loading and activating commissioning file
Commissioning file created on an external PC
Place the externally created commissioning file into directory _N_MPF_DIR.
The file must be started as part program to activate the commissioning file in the NC:
● Select the part program, e.g. _N_MAGKONF_MPF.MPF
● Execute the program with NC Start.
Create PLC data with HMI-Embedded
The data relevant for booting are located in DB 4 from data word 64 onwards
This data must be described by the PLC user program.
References: Function Manual, Tool Manager: Signal description of PLC data
The number of magazines, loading points, spindles and turrets is determined from this data
and used to automatically set up the tool management data blocks (DB 71 to DB 74).
Booting is part of the basic program.
94
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0