Assigning The Bolt Set To A Pipe Part; Creating Bolt Sets - Siemens COMOS Operating Manual

8.12.5

Assigning the bolt set to a pipe part

Aim
Instead of using the standard procedure, you define which bolt set is used for a flanged pipe
part.
Requirement
The required bolt set is displayed on the "Base objects" tab in the Navigator.
Procedure
1. If the bolt set is to be used all the time, regardless of which pipe spec the pipe part belongs
to, navigate to the base object of the pipe part in the pipe part catalog.
Open its properties.
If the bolt set is to be used for a certain pipe spec only, navigate to the base object of the
pipe spec.
Open the properties of the pipe spec element.
2. Click the "Attributes > Connector <Counter>" tab, which describes the connection of the
bolted end.
3. Drag&drop the base object of the bolt set to the "Bolt set" field.
4. Save your entries.
8.12.6

Creating bolt sets

Requirement
You have linked pipe parts with one of the following attachment types:
● Bolted connection
● Hole for bolted connection
● Wafer type
Procedure
You can find additional information on this topic in the "Isometrics" manual, keyword
"Calculating bolts".
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Configuring pipe specs
8.12 Using bolt sets in pipe specs
113