Managing Pipe Specs; Deleting A Pipe Spec; Creating Folders For Structuring The Pipe Specs - Siemens COMOS Operating Manual

Managing pipe specs

7.1

Deleting a pipe spec

Note
Do not delete any pipe spec that is used in the engineering data.
Requirement
The "Pipe spec administration" tab of the PipeSpec Designer is open. See also chapter Calling
the PipeSpec Designer (Page 69).
Procedure
1. To open the "Load pipe spec" window, click the "...". button next to the "Pipe spec" field on
the "Pipe spec administration" tab.
2. Select the required pipe spec in the lower area of the window.
3. Select "Delete" from the context menu.
7.2

Creating folders for structuring the pipe specs

Requirement
The "Pipe spec administration" tab of the PipeSpec Designer is open. See also chapter Calling
the PipeSpec Designer (Page 69).
Procedure
1. To open the "Load pipe spec" window, click the "...". button next to the "Pipe spec" field on
the "Pipe spec administration" tab.
2. In the structure tree, select the node under which you wish to paste a folder.
3. Select the "New > Folder" command in the context menu.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
7
77