Miscellaneous; Connector Table" Tab; Surface Reference Of The "Connector Table" Tab - Siemens COMOS Operating Manual

Configuring pipe specs

8.7 "Connector table" tab

8.6.6

Miscellaneous

Navigating from the branch table to a branch part
1. Open the window with the nominal diameter table using the [...] button.
2. In the nominal diameter table, open the context menu and select "Navigate > Object".
The corresponding pipe spec element is selected in the Navigator.
Resetting the branch table
Requirement: Display mode is "Only show preselected component".
To reset the values in the branch table to the latest version, select the "Reset" command in
the context menu of the branch table.
8.7 "Connector table" tab
On the "Connector table" tab, you determine (from a design point of view) which pipe part is
to be used to connect two facing connection types in the engineering data.
You can also specify for which pipe parts (special parts) additional pipe parts are added at the
connectors during positioning.
8.7.1

Surface reference of the "Connector table" tab

Structure
The "Connector table" tab is divided into two areas:
● Upper half: The connector table
● Lower half: The table for special parts
Connector table
● The table shows the contact faces and connection types set at the pipe spec elements and
lists them in a matrix.
● A list is stored with each table cell. For each connection type combination, COMOS
analyzes which pipe spec elements match on at least one side and displays them in a list.
● You can filter or sort the table by means of the column headers.
● A context menu is available for each cell. You can use its commands to navigate to the
pipe spec element, for example, or open its properties.
100
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA