Dimensions" Tab At Bolts; Dimensions" Tab At Washers - Siemens COMOS Operating Manual

Result
When using the calculation formula to access the standard catalog, COMOS also takes the
parameters you have defined into account.
See also
Structuring by the "Parameter name" attribute (Page 22)
3.4.3

"Dimensions" tab at bolts

Path in the database: "@40 > A20 > Y00 > A10 > A30 > Y00T00055 > A03 > B02 > C01 >
Y00T00055 Dimensions"
Inheritance source for the node of the standard catalog for geometry standards, which saves
the geometry of the bolts.
The actual dimensions are input at the lowest level of the standard geometry tables.
Table
● Defines which lengths are permitted on the basis of the dimensions.
● Display properties:
"Row display": "Extend dynamically", as otherwise you cannot update the table
subsequently in order to add new rows.
● "L<counter>" columns:
Purpose: The length
Values: In the "standard geometry tables" standard catalog, enter the bolt lengths on the
layer which defines the bolt standard.
3.4.4

"Dimensions" tab at washers

Path in the database: "@40 > A20 > Y00 > A10 > A30 > Y00T00055 > A03 > B02 > C03 >
Y00T00055 Dimensions"
Inheritance source for the tab in which you enter the heights of the washers in the "Standard
geometry tables" standard catalog.
The actual dimensions are input at the lowest level of the standard geometry tables.
Table
● Purpose: Defines the height of the washers based on dimension.
● Display properties:
"Row display": "Extend dynamically", as otherwise you cannot update the table
subsequently in order to add new rows.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Preparing for creation and maintenance of pipe specs
3.4 Managing the "standard geometry tables" standard catalog
25