Branch Table" Tab; Surface Reference Of The "Branch Table" Tab - Siemens COMOS Operating Manual

Attribute for the nominal diameter range of a pipe spec element
You will only find the attribute saving the nominal diameter range in the Navigator. The attribute
is not placed on the "Application limits component" tab.
You can embed the XML string on a tab. See also chapter Display nominal diameter range
(Page 40).
See also
Nominal diameter range of a pipe part (Page 40)
"Display for nominal diameter range" tab (Page 53)
8.6

"Branch table" tab

Here you specify which branch part is used if pipes are interconnected directly when
constructing branches. A unique entry is set for each nominal diameter combination.
The table is not evaluated if you have already placed a branch part when constructing the
branch. In this case, the component set as the preselected component for the pipe part type
of the branch part is used.
8.6.1

Surface reference of the "Branch table" tab

Structure
The "Branch table" tab is divided into two areas.
Upper half:
● The branch table and some options for controlling the display of the table and filtering its
content.
● Purpose:
If pipes are interconnected directly during construction, you specify here which branch part
is used based on the nominal diameter.
Lower half:
List of branch parts with legend. Use the [...] button to open the nominal diameter range.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Configuring pipe specs
8.6 "Branch table" tab
95