Siemens COMOS Operating Manual page 24

Preparing for creation and maintenance of pipe specs
3.4 Managing the "standard geometry tables" standard catalog
Purpose:
● Is used to configure the "standard geometry table" standard catalog
● Is assigned to the following attribute at the objects in the standard catalog:
"Y00T00055.Y00A00027 Parameter name"
Structure:
● "Name":
Continuous counter
● "Description":
Describes the function that the object has in the "standard geometry tables" standard
catalog.
● "Value 1" column:
The value entered here is used to determine the path to the geometry table.
The name of the attribute that COMOS is to evaluate for the pipe part in the pipe part catalog
on the "Attributes > 3D geometry" tab
Evaluated attribute
"Y00T00011.Y00A00038 Stand‐
ard"
"Attributes > Connector <1-n>"
tab, "Y00A00090 Nominal pres‐
sure"
"Attributes > Connector <1-n>"
tab, "Y00A00578 Connection type"
Flanges, "Attributes > <Connector
2>" tab, "Y00A00004 Standard"
Procedure
1. Open the following standard table:
"Standard tables > @40 > Y00 > A10 > A90 > Y00N00204 Standard parameterization table"
2. Create a new entry in the standard table:
– "Name": Continuous counter.
– "Description": Description of the parameter, e.g. "Contact face 2"
– "Value 1": Name of the attribute that is evaluated by the calculation formula.
3. Assign the new entry to all structure objects from the "standard geometry tables" standard
catalog as parameters.
4. In the pipe part catalog, generate a calculation formula which uses the new parameter.
See also chapter "Entering the calculation formula (Page 30)".
24
The attribute is found by conducting an evaluation in the following sequence:
1. "Attributes > 3D geometry" tab
2. "Attributes > Connector <1-n>" tab
Structuring feature
Standard
Nominal pressure
Connection type
Flange standard
Operating Manual, 09/2014, A5E32076948-AA
PipeSpec Designer