Assigning Devices And Programs; Loading The Programs Into The Ktp400 And Ktp700 - Siemens SIMATIC HMI KTP400 Manual

4 Installation and Commissioning
4.3.3

Assigning devices and programs

Table 4-6
No. Device
1. KTP400 weather station (Set 11)
2. KTP700 (Set 10)
3. LOGO! weather station (Set 11)
4. Master LOGO! (Set 9)
5. Slave LOGO! (Set 9)
6. LOGO! TDE (Set 9)
4.3.4

Loading the programs into the KTP400 and KTP700

Table 4-7
No. Action/response
Start WinCC and with "Browse", open
1.
68585346_LOGO!_
the project "
Set11 _weather_station_V20".
Then click "Open".
Note:
Repeat the steps of this table for the
68585346_LOGO!_Set11_
project "
HMI_WinCC_V20" of the KTP700,
unless you would like to operate
Set 11 separately.
Click on "Open the project view" to
2.
open it.
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1,
68585346_LOGO!_Set11_weather_station_V21.ap15
68585346_LOGO!_Set11_HMI_WinCC_V21.ap15
68585346_LOGO!_Set11_LOGO!8_weather_station.lsc
contained in the network project
68585346_LOGO!_Set11_LOGO!_8.lnp
68585346_LOGO!_Set11_LOGO!_8.lsc
contained in the network project
68585346_LOGO!_Set11_LOGO!_v20.lnp
09/2018
Program for the device in the zip file
WinCC
20