Denon DN-500AV Owner's Manual page 73

Setting items
Channel Level Test Tone Start : Output test tone.
Set the volume of the test • Front L / F.Height L / Center / F.Height R / Front R / Surround R /
z
tone to be the same when it / S.Back L
S.Back R
is output from each speaker. z When the "Speaker Config." – "S.Back" setting
to "1spkr", "S.Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When "Channel Level" is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 48.
NOTE
• Speakers set to "None" in the "Speaker Config."
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Channel Level" is not displayed.
Default : The "Channel Level" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
the "Return settings to the default?" prompt
is displayed. Select either "Yes" or "No", and
ENTER
press
BD
Setting details
z
/ Surround L / Subwoofer : Select the speaker.
(vpage
(vpage
ENTER
,
.
Setting items
Crossover Freq.
Set the maximum frequency
of the bass signal output
65) is set from each channel to
the subwoofer. Set the
Crossover Frequency to
suit the bass reproduction
capability of the speaker
being used.
65)
Front Sp Setup
Set the front speakers to
use for every surround
mode.
NOTE
This can be set when "Amp
Assign" is set to "Front B"
(vpage 65).
67
Setting details
Crossover : Set the crossover frequency.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
Advanced : Specify crossover frequency for each speaker.
• Front / Center / Surround / S.Back / F.Height : Select the speaker.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
• "Crossover Freq." can be set when the "Bass Setting" – "Subwoofer
Mode" (vpage 66) setting is "LFE+Main", or when you have a
speaker that is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Advanced" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 66).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
2CH DIRECT/STEREO : The front speakers used in the direct, stereo and
pure direct play modes (2 channel) are set in advance.
• A : Front speaker A is used.
• B : Front speaker B is used.
• A+B : Both front speakers A and B are used.
MULTI CH : The front speakers used in modes other than the direct,
stereo and pure direct play modes (2 channel) are set in advance.
• A : Front speaker A is used.
• B : Front speaker B is used.
• A+B : Both front speakers A and B are used.
System Setup