Denon DN-500AV Owner's Manual page 132

GAudioH
Symptom
Audio is not output. • Check the connections for all devices.
• Check the speaker connections and configurations.
• Check whether the audio device power is turned on.
• Adjust the master volume.
• Cancel the mute mode.
• Select a suitable input source.
• Select a suitable input mode.
No sound is • Check if the surround output terminals are connected to the
produced from power amplifier and speakers.
surround speaker.
No sound is • Check if "Amp Assign" is set appropriately in order to output
produced from audio from the surround back terminals.
surround back • Set "Speaker Config." – "S.Back" on the menu to something
speaker. other than "None".
• Set "Surr.Parameter" – "S.Back" on the menu to something
other than "OFF".
• Set the surround mode to something other than "STEREO" and
"VIRTUAL".
No sound is
• Set "Surr.Parameter" – "PLgz Height" on the menu to "ON".
produced from front
• Check if "Amp Assign" is set appropriately in order to output
height speaker.
audio from the front height speakers.
• Set "Speaker Config." – "F.Height" on the menu to something
other than "None".
No sound is • Check the subwoofer connections.
produced from
subwoofer.
• Turn on the subwoofer's power.
• Set "Speaker Config." – "Subwoofer" on the menu to "Yes".
• If "Front" and "Center" for "Speaker Config." are set to "Large",
and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected
surround mode.
BD
Cause/Solution
8, 10, 11,
Symptom
Page
DTS sound is not • Set "Decode Mode" on the menu to "Auto" or "DTS".
output.
C 3,
Dolby TrueHD, DTS- • Make HDMI connections.
12, 15
HD, Dolby Digital
C 6,
Plus audio is not
41, 42,
output.
43, 45
• Check that "Speaker Config." – "Center" or "Surround" is set
Dolby PLg mode or
–
to other than "None". If the speaker system is 2.0/2.1ch, this
DTS NEO:6 mode
20, 52
surround mode cannot be selected.
cannot be selected.
20, 52
• When headphones are used, Dolby PLg or DTS NEO:6 cannot be
19, 52
selected.
80
RESTORER cannot • Check that an analog signal or PCM signal (fs=44.1/48 kHz) is
–
be selected. input. For playback of multichannel signals such as Dolby Digital
or DTS surround, RESTORER cannot be used.
• Switch the surround mode to other than "DIRECT" or "PURE
65
DIRECT".
GControl dock for iPodH
65
Symptom
61
iPod cannot be • Check the iPod connections.
played. • Insert the AC adaptor of the iPod control dock into the power
33
outlet.
• Switch the input source to "DOCK".
61
65
66
C 6,
41, 42,
43, 45
–
65
65, 66
126
Cause/Solution
Cause/Solution
Page
80
8
65
–
62
33
Page
12
–
19