Management Commands; Network Interface Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
4.

Management Commands

This section provides descriptions of the following management commands for the D-LINK OS CLI:
•

"Network Interface Commands"

•
"IPv6 Management Commands"
•
"Console Port Access Commands"
•
"Secure Shell Commands"
•
"Management Security Commands"
•
"Access Commands"
•
"AAA Commands"
•
"User Account and Password Commands"
•
"Access Commands"
•
"SNMP Commands"
•
"RADIUS Commands"
•
"TACACS+ Commands"
•
"Configuration Scripting Commands"
•
"Pre-login Banner, System Prompt, and Host Name Commands"
•
"Front Panel TAP Interfaces"
Note: The commands described in this section are all included in one of three functional groups:
•
Show commands, which are commands that display switch settings, statistics, and other
information.
• Configuration commands, which are commands that can be used to configure the features and
options of the switch. Please note that, for every configuration command, there is a
corresponding show command that shows the configuration setting.
•
Clear commands, which are commands clear some or all of the user-applied settings, returning
the configurations to factory defaults.
Network Interface Commands
The commands used to configure a logical interface for management access are described in this section.
Please see
4-1 enable (Privileged EXEC access)
This command provides the user with access to the Privileged EXEC mode. From the Privileged EXEC
mode, the network interface can be configured.
enable
Parameters
None
Default
The default is None.
Command Mode
User EXEC
"network mgmt_vlan" for information on how to configure the management VLAN.
19