Ospf Interface Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
packets
virt-packets
state-change
all
if-state-change
neighbor-state-change
virtif-state-change
virtneighbor-state-change
Default
The default is Disabled.
Command Mode
Router OSPF Config

OSPF Interface Commands

7-164 ip ospf area
Enable OSPFv2 and set the area ID of an interface or range of interfaces. The area-id is an IP address
formatted as a 4-digit dotted-decimal number or a decimal value in the range of 0-4294967295. This
command supersedes the effects of the network area command. It can also be used to configure the
advertiseability of the secondary addresses on this interface into the OSPFv2 domain.
No command disables OSPF on an interface.
ip ospf area area-id [secondaries none]
no ip ospf area [secondaies none]
Parameters
area-id
secondaries none
Default
The default is Disabled.
Command Mode
Interface Config
Packet retransmission on non virtual interfaces.
Packet retransmission on virtual interfaces.
Enable/Disable state change traps.
Enable/Disable all Traps.
Non virtual interface state changes.
Neighbor state changes on non virtual interfaces.
Virtual interface state changes.
Non virtual neighbor state changes.
Configure OSPF area to which the specified interface belongs. Indicate
an OSPF area ID as decimal value (0-4294967295) or an IP address
format.
Enable/Disable the advertisability of all secondary addresses.
756