DES-3326SR Layer 3 Fast Ethernet Switch User's Guide
•
A front-panel slide-in module slot for Gigabit Ethernet ports
can accommodate a 2-port 1000BASE-T Gigabit Ethernet
module, a 2-port 1000BASE-SX Gigabit Ethernet module, a
2-port 1000BASE-LX Gigabit Ethernet module, or a 2-port
GBIC-based Gigabit Ethernet module.
•
Twenty-four high-performance, NWay Ethernet ports all of
which operate at 10/100 Mbps with Auto-MDIX function for
connections to end stations, servers and hubs. All ports can
auto-negotiate between 10Mbps or 100Mbps, full or half
duplex, and flow control.
Rear Panel
The rear panel of the switch contains an AC power connector.
Figure 3-2. Rear panel view of the Switch
The AC power connector is a standard three-pronged connector
that supports the power cord. Plug-in the female connector of
the provided power cord into this socket, and the male side of
the cord into a power outlet. Supported input voltages range
from 100 ~ 240 VAC at 50 ~ 60 Hz.
Between the fan outlet and the power cord is the outlet for the
redundant power supply. Using the DPS-200 14-pin DC power
cable, connect the DES-3326SR to the DPS-200 redundant
power supply. The redundant power supply ensures that
service will not be interrupted in the event of an internal power
supply failure.
15