D-Link DES-3326SR User Manual page 177

DES-3326SR Layer 3 Fast Ethernet Switch User's Guide
Stacking Information
To change a switch's default stacking configuration (for
example, the order in the stack), you must use the console
Command Line Interface.
The number of switches in the switch stack (up to 8 − total) are
displayed in the upper right-hand corner of you web-browser.
The icons are in the same order as their respective Unit
numbers, with the Unit 1 switch corresponding to the icon in
the upper left-most corner of the icon group.
Figure 6 - 12. Switch Stack Display
In this case, there are two switches in the switch stack. The
Unit 1 (master) switch is on top and highlighted in blue. The
Unit 2 (slave) switch is below and not highlighted. To select a
switch in the switch stack to configure, simply click on the
corresponding switch's icon.
Figure 6 - 13. Switch Stack Icons
Here, the switch Unit 2 (slave) has been selected.
When the up to 8 DES-3326SR switches are properly
interconnected through their optional Stacking Modules,
165