Table of Contents
Advertisement
64
Using the thread cutter
To use the thread cutter:
1.
Press the pedal to position -2 (3).
The thread can be cut both with the machine running and with
the machine at a standstill.
Important
If set incorrectly, the thread cutter may prevent a proper sewing
start after the thread has been cut.
If a proper sewing start following the cutting of the thread is not
possible, check the following:
• Check and, if necessary, readjust the thread tension
• Activate soft start (see Instructions for use DAC basic/classic)
• Increase the number of stitches during soft start
(see Instructions for use DAC basic/classic)
• Increase the length of the needle thread end by setting the
pre-tensioner (5).
When the machine is at its upper automatic position, the
length of the needle thread end should be 60-80 mm.
The longer the needle thread end is, the less likely is the
occurrence of skipped stitches.
Information
The shorter the needle thread is, the more likely the machine is
not to start sewing.
Activating or deactivating the thread cutter
To activate or deactivate the thread cutter:
1.
Press the button for the thread cutter on the OP1000.
When the thread cutter is activated, the LED on the OP1000
will be on.
When the thread cutter is deactivated, the LED on the OP1000
will be off.
Operating Instructions 967 - 02.0 - 11/2016
Operation
Advertisement
Table of Contents
