Setup
Operating Instructions 967 - 02.0 - 11/2016
Fig. 52: Inserting the machine head (2), machines with long arm
①
②
③
5 mm
④
⑤
(1) - Eye bolt
(2) - Rubber mounts
(3) - Corner rubber inlays
(4) - Permanent magnet of the
tilt sensor
(5) - Screws
To insert the machine head:
1.
Insert the rubber mounts (2) and tighten.
2.
Insert the rubber corner inlays (3).
3.
Tighten the permanent magnet of the tilt sensor (4) using the
screws (5).
4.
Insert the eye bolt (1) into the machine head.
(6) - Pull rod
(7) - Pin
(8) - Locking washer
(9) - Torsion spring
(10) - Clips
⑩
⑨
⑧
⑦
⑥
97