Special Operation In Master Mode; Master Mode Setting - Delta AH500 Manual

10.7 Special Operation in Master Mode

10.7.1 Master Mode Setting

If AH10DNET-5A is in slave mode, it can be set to the master mode via the DeviceNet Builder
software.
1. PC accesses an AH500 series CPU module via USB after connecting the device according to
the following figure.
DeviceNet Builder
RS232
Note: The introduction in this section is made in the USB communication method.
2. Open ISPSoft, select "File" >> "New" >> "New" and then the following dialog box appears where
select the corresponding PLC.
Note: The PLC used in this section is AHCPU530-EN.
Ch a pt er 1 0 De v ic eN e t Com m unic at i on Mo d ul e A H 10 DN ET
C U530-EN P
P 05 S
PS05
CPU530-EN
AH10DNET-5A
10DNET
1 0 - 1 9