Main Seat Removal/Installation; Seat Catch Stay Removal/Installation; Seat Lock Cylinder Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
MAIN SEAT

MAIN SEAT REMOVAL/INSTALLATION

Unlock the main seat [1] using the ignition key [2].
Remove the seat while pulling it forward and upward.
Install the seat while aligning its hook [3] with the
retainer on the rear carrier.
Push the seat downward, and lock it.
SEAT CATCH STAY REMOVAL/
INSTALLATION
Remove the tank rear cover (page 2-10).
Remove the bolts [1] and pull up the seat catch stay [2].
Disconnect the seat lock cable [3] from the stay.
Remove the bolt [4] and seat catch hook [5].
Installation is in the reverse order of removal.
• Apply grease to the seat catch hook sliding area.
• Align the seat catch hook boss with the stay hole.
SEAT LOCK CYLINDER REMOVAL/
INSTALLATION
Remove the ETC tray (page 2-11).
Disconnect the seat lock cable [1] from the seat lock
cylinder [2] and stay [3].
Remove the lock spring [4], cylinder, and stay.
Installation is in the reverse order of removal.
• Align the lug [5] of the cylinder with the grooves [6]
of the rear fender B, lock spring, and stay.
2-4
[3]
[1]
[4]
[4]
[1] [3]
[2]
[2]
[1]
[5]
[3]
[5]
[2]
[6]