Clutch Pressure Plate Bearing Replacement - Honda CRF1000 Shop Manual

dummyhead dummyhead
Check the following of the clutch center [1] for scratch,
damage, abnormal wear and deformation.
– Cam areas [2]
– Grooves
– Disc sliding surface
Replace the clutch center if necessary.
Check the following of the clutch outer [1] for scratch,
damage, abnormal wear and deformation.
– Grooves
– Needle bearing [2]
– Primary driven gear [3]
Replace the clutch outer if necessary.
For bearing replacement (page 12-12)
Inspect the following parts for scratch, damage,
abnormal wear and deformation. Replace if necessary.
– Clutch springs
– Clutch spring seats
– Clutch lifter pin
– Clutch discs/plates
– Judder spring
– Judder spring seat
– Clutch outer guide
Measure each part according to CLUTCH/GEARSHIFT
LINKAGE SPECIFICATIONS (page 1-8).
Replace any part if it is out of service limit.
• Replace the clutch springs as a set.
• Replace the clutch discs and plates as a set.
CLUTCH PRESSURE PRATE BEARING
REPLACEMENT
Drive bearing out.
Coat a new bearing with engine oil.
Drive the bearing [1] into the clutch pressure plate with
its marked side facing up until it is fully seated using
special tools.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 17 mm [4]
CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
[2]
[2]
07749-0010000
07746-0010100
07746-0040400
[1]
[1]
[3]
[2]
[3]
[4] [1]
12-11