Ignition Coil Tray Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
IGNITION COIL
IGNITION COIL TRAY REMOVAL/
INSTALLATION
Disconnect the spark plug cap (page 3-6).
Remove the air cleaner housing (page 7-11).
Release the ignition switch 2P (Brown) [1] and
immobilizer receiver 4P (Black) [2] connectors from the
ignition coil tray.
Release the main wire harness clip [3].
Loosen the band screws (throttle body side) [1].
Disconnect the throttle body from the insulators and pull
it rearward.
Disconnect the ignition coil wire sub harness 6P (Black)
connector [1].
Releasing the bosses [1] from the grommets [2] by
pulling the ignition coil tray assembly [3] rearward, and
remove the tray assembly.
Installation is in the reverse order of removal.
• Route the wires properly (page 1-26).
• Refer to the throttle body installation (page 7-15).
IGNITION SYSTEM
[3] [1]
Left side: Right side:
[1]
[1]
[2]
[1]
[3]
[2]
[1]
[1]
5-9