Handlebar Lower Holder Removal/Installation; Handlebar Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
HANDLEBAR LOWER HOLDER
REMOVAL/INSTALLATION
Remove the handlebar (page 17-4).
Temporarily install the handlebar [1] and handlebar
upper holders [2] that you removed and tighten the
socket bolts [3].
Remove the nuts [4], washers [5], lower holders [6]/
handlebar assembly, washers [7], and damper rubbers
[8] from the top bridge.
Remove the handlebar from the lower holders.
Install the damper rubbers, washers, and lower holders
to the top bridge.
Temporarily install the handlebar on the lower holders
to secure the lower holders.
Install the washers and nuts and tighten the nuts to the
specified torque.
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
Remove the handlebar from the lower holders.
INSTALLATION
• The scratches or bend of the handlebar may cause
breakage. Replace the damaged handlebar with a
new one.
• Route the hoses, cables, and wires properly (page
1-26).
Clean the inside surface of the handlebar grip [1].
Apply Honda Bond A or an equivalent to the inside
surface of the grip and outside surface of the handlebar
[2].
Wait 3 – 5 minutes and install the grip.
Rotate the grip for even application of the adhesive.
Allow the adhesive
to dry for 1 hour
before using.
FRONT WHEEL/SUSPENSION/STEERING
[3]
[6]
[7]
[8]
[2]
[2]
[1]
[6]
[7]
[8]
[4]/[5]
[1]
17-7