Swingarm Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
Install the snap ring [1] into the right pivot groove
securely.
• Do not reuse the snap ring which could easily spin in
the groove.
• Make sure that the snap ring is firmly seated in the
groove.
INSTALLATION
Apply a thin coat of grease to the swingarm pivot bolt
sliding surface.
Set the drive chain [1] onto the swingarm [2] and install
the swingarm to the frame.
Install the swingarm pivot bolt [3] from the left side.
Apply engine oil to the swingarm pivot nut threads and
seating surface.
Install the swingarm pivot nut [4].
Tighten the swingarm pivot nut to the specified torque.
TORQUE: 80 N·m (8.2 kgf·m, 59 lbf·ft)
Set the cushion arm and install the upper cushion arm
bolt [1] from the left side.
Install and tighten the upper cushion arm mounting nut
[2] to the specified torque.
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
Install the parking brake cable guide [1] and bolt [2].
CRF1000D:
Tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
REAR WHEEL/SUSPENSION
[1] [2]
[1]
[1]
[4]
[3]
[1]/[2]
[2]
18-17