Change Password - Runco DTV-1200 Owner's Manual

Change Password

What can be done?
The password code (4 digits) can be changed to a new one.
This item is password protected. First the actual password should be entered before continuing.
Note:
Password function is only active if the jumper on the controller is in the 'ON' position.
How to select?
To select Change Password :
1. Push the cursor key
2. Press ENTER to display the password menu (menu 2).
If it is the first time you enter a password protected item, enter your password and press ENTER.
The current password is displayed. The new password must consist of 4 digits between 0 and 9.
How to enter a new password?
Perform the following:
1. Push the cursor key
2. Press a numeric keys to enter the new digit.
3. Repeat for the other digits.
4. Press ENTER to save the new password.
Before saving the new password, a confirmation screen will be displayed (menu 3).
5. When the displayed password is correct, press ENTER to save.
6. If not correct, press EXIT to cancel the saving.
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with or
then <ENTER>
<EXIT> to return
menu 1
or to highlight 'Change Password' (menu 1).
or to select the digits to be changed (menu 2).
PASSWORD
Enter new password :
0 0 0 0
Use and
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
menu 2
CHANGE PASSWORD
to select,
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
menu 3
56
!