Selecting Setup Pattern - Runco DTV-1200 Owner's Manual

previous page
RANDOM ACCESS
ADJUSTMENT MODE
SETUP PATTERN
SELECTION

Selecting Setup Pattern

Set up of the Selected Setup Pattern
If an external source is connected to the projector, menu 1 will be displayed.
To select the desired setup pattern, perform the following:
1 Push the cursor keys
2 Press ENTER to select.
Choose a setup pattern from below:
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 01
Select with or
then <ENTER>
<EXIT> to return
menu 1
Genlocked pattern: internally generated cross hatch pattern, locked on the scan rate of external source.
Internal # pattern: internally generated cross hatch pattern and locked on internal generated sync signals. (No
external source necessary)
If no external source is connected to the projector, the internal cross hatch pattern menu will be displayed.
Note: The menus in this manual are created for an external source, connected to one of the inputs, and the
'Genlocked Pattern' is selected.
RED
GREEN
BLUE
COLOR SELECT
RED AND GREEN
BLUE AND GREEN
RED AND BLUE
GREEN ONLY
CONVERGENCE RED ON GREEN
BLUE ON GREEN
RED
GREEN
FOCUSING
BLUE
or to highlight the desired setup pattern
32