Flyback Turnover Point; Menu Position - Runco DTV-1200 Owner's Manual

Dtv capable crt projector
Table of Contents

Advertisement

Flyback Turnover Point

What can be done?
The horizontal flyback time for horizontal frequencies can be long or short. The turnover point from long to short
can be installed by the user himself.
Set Up of the Flyback Turnover Point
To set up the flyback turnover point:
1. Push the cursor key
2. Press ENTER to display the flyback turnover point (menu 2).
The actual turnover point frequency will be filled in.
3. Select the digits with the left or right cursor keys and enter the new value with the digit keys on the Remote.
The flyback turnover point frequency should be somewhere between 90 kHz and 130 kHz.
4. Press ENTER to select.
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Select with
or
then <ENTER>
<EXIT> to return

Menu Position

What can be done?
The bar scale menu, warning and message boxes can be displayed in the right lower corner or in the middle of
the screen.
How to change the position?
To change the position:
1. Push the cursor key
2. Press ENTER to toggle between STANDARD or MIDDLE.
COMMON SETTINGS
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION :
STANDARD
Select with
or
then <ENTER>
<EXIT> to return
or
to highlight 'Flyback turnover point' (menu 1).
FLYBACK TURNOVER POINT
Enter new frequency :
0 9 0 kHz
Use the
and reprogram with
numeric keys
Lowest point is 90 kHz.
Highest point is 130 kHz.
menu 1
<ENTER> to confirm
<EXIT> to return.
or
to highlight 'Menu position' (menu 1).
menu 1
or
to select,
menu 2
75

Advertisement

Table of Contents
loading

Table of Contents