Rgb Source To Input 3; Rgb Source With Composite Sync To Input 4/5 - Runco DTV-1200 Owner's Manual

RGB Source to Input 3

Which signal to Input 3
Connect your RGB source with sync on green, composite or separate sync via an interface to Input 3.
Always use an interface when a computer and local monitor have to be connected to the projector as the signal
cable coming from the computer is limited to 60 cm due to interferences.
Pin configuration D9 connector of the Analog input.
1 Not connected
2 Ground RGBS
3 RED
4 GREEN
5 BLUE
6 Ground RGBS
7 Ground RGBS
8 Hor/comp. sync
9 Vert. sync
OFF ON
Input Select Input 3
With the Remote, press button 3

RGB Source with Composite Sync to Input 4/5

Which signal to Input 4/5
RGB input terminals with separate H and V Sync inputs, Composite Sync Input or with Sync on green (BNC ter-
minals). The Projector detects automatically where the sync signal is located. This is the Input where Video
Processors (such as the Runco VHD-4404 Ultra) or high definition sources should be connected.
OFF ON
RGB Sync on green or separate Sync Input selection
With the remote, press:
- Button 4 for Sync on green
- Button 5 for Separate Sync
AC Input
R G
Future Expansion
ANALOG INTERF. 120MHz
ON INPUT
B H V
OFF
R G
INP INP
75 ohm term. inver.
AC Input
R G
Future Expansion
4404 ULTRA
R U N CO
M U L T I F I L M
OFF/ON
75 Ohm
B H V S-Video Video
INPUT 4/5 INPUT 2
OFF/ON
75 Ohm
B H V S-Video Video
INPUT 4/5 INPUT 2
12
OFF/ON
75 Ohm
Green: Operation
Red: Standby
12 Volt
Trigger
Status
INPUT 1
OFF/ON
75 Ohm
Green: Operation
Red: Standby
12 Volt
Trigger
Status
INPUT 1