Getting Started; Remote Control & Local Keypad - Runco DTV-1200 Owner's Manual

GETTING STARTED

Remote Control & Local Keypad
Battery Installation in the Remote
Two batteries are packed together with the Remote. Before using your Remote, install first these batteries.
1 Remove the battery cover on the backside by pushing the handle a little towards the bottom of the Remote.
2 Lift up the top side of the cover at the same time.
3 Insert the batteries as indicated in the Remote.
4 Put the battery cover on its place.
How to replace the batteries in the Remote?
To replace the batteries :
1 Remove the battery cover on the backside by pushing the handle a little towards the bottom of the Remote.
2 Lift up the top side of the cover at the same time.
3 Push on the + side of the battery towards the - side
4 Lift up the battery at the same time.
5 Repeat for the second battery.
6 Insert the batteries as indicated in the Remote (battery type AA or LR6 or equivalent).
7 Put the battery cover on its place.
Note: only important if more than one projector is installed in the room :
1. The default address is zero (0) or (1). The standard Remote is setup for common address zero.
To change the common address of the Remote, contact a Runco service center. If it is necessary to program
the projector address into the Remote, see 'Projector Address'.
2. Projector address has to be reprogrammed everytime the battery is changed, the Remote will always switch
to the default address.
14