Ignition - Biasi Inovia 25S ERP User Manual And Installation Instructions

If you experience any difficulty with the
operation of the boiler, switch off the
boiler immediately at the fused spur iso-
lation switch and contact your Installer
or an approved Service Engineer.
Air introduced into the boiler during this fill-
ing process will vent through the automatic
air purger fitted to the boiler. You may also
find it necessary to vent air from your radia-
tor circuit using your radiator key, however
be aware that excessive venting will cause
the pressure in the system to drop.
Always ensure that the pressure gauge is
set at the required pressure.
2.3

Ignition

• Check that the valves located in the lower
part of the boiler are open Fig. 2.3.
Open
position
Fig. 2.3
• Turn on the electricity supply to the boil-
er, switching on the fused spur isolation
switch. The LCD display displays the state
within which the boiler is found (last mem-
orised) Fig. 2.4.
- 14 -
INSTRUCTIONS FOR USE
Fig. 2.4
Time/Day/Date setting
Enter "programming mode" by holding
down key 18 for 5 seconds (Fig. 2.7) until
the display indicates the
Use keys 16 (decrease) and 17 (increase)
Fig. 2.7 to set the time, day and date values,
using keys 10 and 11 to move from one pa-
rameter to the next.
Press key 18 briefly to save the values en-
tered and the display will indicate OK to
confirm (Fig. 2.5).
Fig. 2.5
The display will indicate:
for hour and minutes
for the day of the week
(1=Mon, ..., 7=Sun)
for day and month
for the year
for the format
Fig. 2.6
Stand-by
Hyphens are turned
on in sequence to
simulate running
Winter
symbol.