Biasi Inovia 25S ERP User Manual And Installation Instructions page 17

which take you back to the Time Bracket
which will be flashing to set use key's 17
or 16.
To confirm once time has been set press
key 18 then 13 to exit back to the day/group
of days selection (Fig. 2.13).
Fig. 2.13
Repeat this sequence for P2 on & P2 off the
programmes goes up to P4 for each day or
group of days Fig. 2.14.
Fig. 2.14
Any unused programmes must be set to 0.
Once set to 00:00 confirm with key 18 and
the related automatic off time brackets will
be set to 00:00 (Fig. 2.15).
Fig. 2.15
INSTRUCTIONS FOR USE
To exit programme, hold down Key 13 for 5
seconds or wait 60 seconds.
N.B.: If you re-enter the programming mode
and modify the time settings your new val-
ues will automatically over write the old
ones providing you press the 13 and then
18 keys.
Emergency programmer reset:
To reset all time brackets press and hold
keys 14 & 18 simultaneously for 5 seconds,
the Central heating will run continually eve-
ry day for 24 hours.
Resetting will be confirmed by a flashing
RESET along with the symbol
Programmer override Function
This mode temporarily excludes the auto-
matic programme without modifying it.
The Programming range is 1 to 23 hours
and from 1 to 30 days.
10
11
12
13 14
Fig. 2.16
Below are the different settings:
- oFF = Override function disabled (clear
any pre setup override program).
- ch on = Timed manual heating function
active (on for "x" period), (
and
- ch oF = Timed manual heating function off
(off for "x" period), (
flash).
.
18
17
16
15
will flash).
and will
- 17 -
,