Nortel CallPilot 100 Set Up And Operation Manual page 34

34 Chapter 3 Setting up AMIS
4 Set the Dialing Translation properties:
Long Distance Access Code This prefix is removed from any numbers that do not require it to make
Area Code
Access Code
Enable Reply Translation
5 Click the Submit button.
N0008713 01
the call. This simplifies creating the Dialing Translation Table. For
North America, set the long distance access code to 1. The default for
this property is none. The length of this property is a maximum of two
digits.
The system prefixes an area code to a phone number if the caller who
entered the number did not enter an area code. If the addressing
information attached to a message is missing an area code, the area
code is prefixed to the number. The system considers the area code
missing if the number has fewer than 10 digits. The default for this
property is none. The maximum length of this property is 6 digits.
After Dialing Translation, this number prefixes all numbers, to access
the local telephone network. The access code is required if CallPilot is
installed behind a PBX. In North America, the access code is usually
9. If CallPilot is connected directly to CO lines, set the Access Code to
none. The default for this property is none. The maximum length of
this property is 16 digits.
If you use AMIS, you must enable Reply Translation. The default for
this property is not enabled.