Creating Network Sites; Setting The General Networking Properties - Nortel CallPilot 100 Set Up And Operation Manual

Chapter 4

Creating network sites

The procedures in this chapter are for Digital and AMIS networking. If you use digital networking
you must have configured name mapping by DNS or hosts files on your system before you can add
network sites. See
your system's name mapping with ping and nslookup commands. On CallPilot 100/150 you can
test your system's name mapping by adding a network site.

Setting the general networking properties

The general networking properties control how your site interacts with other networking sites.
When you install Message Networking all of the properties are enabled except for Network
Broadcast Messaging and Network Group List Messaging.
To set the general networking properties
1
Start CallPilot Manager.
2
Click the Networking heading.
3
Click General Properties link.
The General Networking Properties page appears.
"Setting up Digital Networking" on page 13
CallPilot Message Networking Set Up and Operation Guide
for more information. You can test
43