Lighting Instructions - Jøtul GF 400 DV IPI Sebago Installation And Operation Instructions Manual

139548-N GF 400 DV IPI 7/21
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do Not try to light
the pilot by hand.
B. BEFORE LIGHTING, smell all around the appliance
area for gas.
Be sure to smell next to the floor because some gas
is heavier than air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame
• Open windows.
• Do not light this or any other appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
39

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING.
CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
neighbor's
phone.
PILOT MODE
OPERATING INSTRUCTIONS
CPI
1. STOP! Read the safety information above.
ProFlame II
Remote
2. Set the thermostat, if equipped, to the lowest
BURNER
setting.
3. Set the Burner switch to the "OFF" position.
ON
4. This appliance is equipped with an ignition
OFF
device which automatically lights the pilot.
Do not try to light the pilot by hand.
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
PILOT MODE
CPI
Pilot
Controls
Proflame 2
Remote
BURNER
Burner
ON
Controls
OFF
If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you do not
smell gas, go to the next step.
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
WARNING:
• If your gas supplier cannot be reached, call the
fire department.
C. Use only your hand to turn the gas control knob.
Never use tools. If the knob will not turn by hand, do
not try to force it or repair it.
Call a qualified technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified ser-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
IPI
6. Set the Pilot Mode switch to CPI for continuous
operation. The pilot will light and remain lit for
up to seven days before automatically shutting
down. The pilot will then re-ignite at the next call
T-STAT
for heat.
OR
Set Pilot to IPI for thermostatic operation. The
pilot will light only when there is a call for heat.
7. Set the Burner switch to the "ON" or "T-STAT"
position.
IPI
T-STAT
8. Set the thermostat to the desired setting to light
the burner. If the appliance will not operate,
follow the instructions "To Turn Off Gas To
Appliance", and call your service technician or
gas supplier.
3. Set the Burner switch to the "OFF" position.
4. Close control access door.
PILOT ASSEMBLY