Change The Pedal Settings - Roland FC-300 Owner's Manual

Control Change Mode

Change the Pedal Settings

You can freely change the settings for each pedal.
1
In the Control Change Mode's top screen, press PARAMETER [
2
Pressing PARAMETER [
3
Press VALUE [
MIDI Messages
This selects the MIDI messages to be transmitted.
fig.05-009
• OFF
These do not output MIDI messages.
• CC#1–CC#31, CC#33–CC#95
These output Control Change messages.
When assigned to an expression pedal, consecutive values are output within the
range set with the Range parameter. When assigned to a control pedal, the
maximum value is output when the switch is on, and the minimum value is output
when the switch is off.
• MIDI START / MIDI STOP / MIDI CONTINUE / MMC STOP / MMC PLAY /
MMC DEF PLAY / MMC FAST FWD / MMC REWIND / MMC REC STROBE /
MMC REC EXIT / MMC REC PAUSE / MMC PAUSE
This transmits MIDI Realtime messages and MMC messages.
When assigned to an expression pedal, messages are output once the pedal is
pressed downward past the halfway point; when assigned to a control pedal or other
switch, the messages are output when the switch is on.
• P.BEND / CH.PRS
These transmit various Pitch Bend messages and Channel Pressure messages.
When assigned to an expression pedal, consecutive values are output within the
range set with the Range parameter. When assigned to a control pedal, the
maximum value is output when the switch is on, and the minimum value is output
when the switch is off.
24
] [ ] to show the pedal setting screens.
] [ ] to change the value.
MIDI Message
].
The settings made for the
pedals are lost when the pedal
settings are switched. To save
settings made for the pedals,
save them as pedal settings.
For more detailed information,
see "Storing Controller
Numbers Assigned to the
Pedals (Pedal Settings)" (p.
26).