Roland FC-300 Owner's Manual page 20

Standard Mode
Range
This sets the range for values that are transmitted.
fig.05-009
Minimum Maximum
Mode
This sets the switch mode.
fig.05-009
Value
LATCH
MOMENTARY
AMP Ctl Op (Amp Control Operation)
This selects whether or not the AMP CONTROL jack is to be controlled.
fig.05-009
AMP CONTROL
1 jack
When the AMP Ctl Op parameter is set to ON and the AMP Polarity parameter is set
to Normal, control of AMP CONTROL with the pedal functions as shown below.
fig.05-009
When the pedal is OFF
(amps channel switching jack)
When the pedal is ON
(amps channel switching jack)
4
When you have finished making the settings, press [EXIT] to return to the
initial screen.
The settings are saved, and the FC-300 returns to the initial screen.
20
Explanation
The ON and OFF will alternate each time you press the pedal.
The value will be ON while you press the pedal, and OFF when you
release the pedal.
AMP CONTROL
2 jack
Guitar Amp
(AMP CONTROL jack)
Guitar Amp
(AMP CONTROL jack)
Closed
FC-300
Open
FC-300
The Range parameter is
enabled when CC#, P.BEND,
or CH.PRS is selected.
The Mode parameter and AMP
Ctl Op parameter are enabled
when a control pedal or other
switch function is selected.
This parameter is ignored
when the pedal is used as a
expression pedal.
You can change the polarity of
the AMP CONTROL jacks. For
more detailed information, see
"Setting the Polarity of the
AMP CONTROL Jacks" (p.
50).