Restoring The Factory Settings (Factory Reset); How To Update System Software - Roland GT-6 Service Notes

15. Calibrate EXP
fig.LCD26
1) The maximum and minimum values of the EXP pedal are set up.
fig.LCD27
fig.arrow
fig.LCD26
2) To set up the minimum value, press the [WRITE] button.
fig.LCD28
fig.arrow
fig.LCD26
3) Fully press the EXP pedal and release your hands.
4) To set up the maximum value, press the [WRITE] button.
When the calibration setup is completed, will automatically proceed to the
next inspection.
16. Factory load
fig.LCD29
To overwrite the factory preset data, press the [WRITE] button three times.
fig.LCD30
This ends test mode.
When the following displayed appears, turn off the power.
17. DIGITAL OUT
After the test mode is completed, connect external equipment that has a
DIGITAL IN terminal to DIGITAL OUT, and confirm that the sound is
properly output from DIGITAL OUT of the GT-6.
RESTORING THE FACTORY
SETTINGS (FACTORY RESET)
1.
Turn off the power.
2.
While holding down PREAMP/SPEAKER On/Off button and [TYPE
VARIATION], turn on the power.
The Factory Reset range setting screen appears in the display.
fig.FR-1e
The area of data you wish to factory reset.
* To cancel Factory Reset, press [EXIT] button.
3.
Press PARAMETER [<] [>] button to move the cursor, and rotate the
PATCH/VALUE dial to specify the range of settings you want to restore
to factory settings.
System:
System parameters, Harmonist scales, Auto Riff phrases, and Preamp,
Overdrive/Distortion, and Wah Custom Edit parameter settings
#1-1-#35-4:
Settings for Patch Number 1-1 through 35-4
4.
If you want to proceed with the factory reset, press [ENTER] button.
The specified range of data will be returned, and return to the Play
screen.
HOW TO UPDATE SYSTEM
SOFTWARE
Required items
• Sequencer (MC-80, etc.)
• MIDI cable
• Update Disk (#17041087)
* Notes
Do not turn the GT-6 unit's power off while writing the system software.
The GT-6 will not operate because the system will not be properly
written into the flash ROM.
* Notes
After updating, execute "TEST:15.Calibrate EXP" and "TEST:16.Factory
Load" while in the test mode.
The System Update Via SMF
The GT-6 system is supplied in standard MIDI file (SMF) format.
The following SMF data is stored on the disk. Starting with GT6_01.mid,
transfer all data to the GT-6 in the respective order.
GT-6 System Ver.*.** SMF Disk : GT6_01.mid, GT6_02.mid, GT6_03.mid,
GT6_04.mid, GT6_05.mid, GT6_06.mid, GT6_07.mid, GT6_08.mid
Update the GT-6's system in the following
order.
1.
Using a MIDI cable, connect the MIDI OUT connector of the sequencer to
the MIDI IN connector of the GT-6.
2.
Turn the GT-6's power on while pressing the [FX-2] and [PEDAL
ASSIGN] and [UTILITY] buttons simultaneously.
The unit is in reception standby status if the LCD displays "Flash Update
ALL BLOCK" then displays "Waiting SMF Data [GT6_01.mid]".
GT-6(T)
19