Table of Contents
Advertisement
Pedal Settings (Control/Expression)
Connect your foot switch to the SUB CTL 1, 2/SUB EXP jack as shown in the illustration, and set its POLARITY switch.
When Connecting an FS-5U
Cable:
1/4" phone type
fg
1/4" phone type
Using Pedals to Control the
Parameters
Here's how to assign the parameters that will be controlled by the
ACCEL/CTL, EXP, SUB EXP, SUB CTL1, and SUB CTL2 pedals.
For details on each pedal, refer to "Front Panel" (p. 20) and "Rear Panel
(Connections)" (p. 22).
Assigning the ACCEL/CTL, EXP SW, SUB
CTL1, and SUB CTL2 Functions
1.
Press the [CTL/EXP] button .
2.
Turn knob [4] to select the pedal whose assignment you
want to specify .
When Connecting Two FS-5Us
or
POLARITY switch
Cable:
Stereo 1/4" phone type
1/4" phone type x 2
Cable:
Stereo 1/4" phone type fg
Stereo 1/4" phone type
When Connecting an FS-6
or
MODE/POLARITY switch
3.
Use knob [5]–[8] to set the parameter that you want to
control .
Parameter
Value
Page 1
You can assign a variety of functions, such as
turning each effect on/off or switching the preamp
channel. For details on all parameters, download the
[5]
FUNC
"GT-100 Parameter Guide" (PDF file) located under
"GT-100" in the list of "Owner's Manuals" on the
Roland website (http://www.roland.com/support/
en/).
OFF, ON
[6]
MIN
(or STOP, START)
OFF, ON
[7]
MAX
(or STOP, START)
This sets the behavior of the value each time the
switch is operation.
MOMENT
SOURCE
[8]
MODE
TOGGLE
* To be able to apply an Accel effect (p. 19) using the ACCEL/CTL
control pedal, you need to set ACCEL/CTL FUNC to ACCEL, and
set SOURCE MODE to MOMENT.
4.
Press the [EXIT] button to return to the Play screen .
Explanation
This sets the value for times
when the switch is Off.
This sets the value for times
when the switch is On.
The normal state is Off
(minimum value), with the
switch On (maximum value)
only while the footswitch is
depressed.
The setting is toggled On
(maximum value) or Off
(minimum value) with each
press of the footswitch.
33
Advertisement
Table of Contents
