Roland FC-300 Owner's Manual page 25

Range
This sets the range for values that are transmitted.
fig.05-009
Minimum Maximum
Mode
This sets the switch mode.
fig.05-009
Value Explanation
LATCH The ON and OFF will alternate each time you press the pedal.
MOMENTARY The value will be ON while you press the pedal, and OFF when you re-
lease the pedal.
AMP Ctl Op (Amp Control Operation)
This selects whether or not the AMP CONTROL jack is to be controlled.
fig.05-009
AMP CONTROL
1 jack
When the AMP Ctl Op parameter is set to ON and the AMP Polarity parameter is set
to Normal, control of AMP CONTROL with the pedal functions as shown below.
fig.05-00fig.05-009
When the pedal is OFF
(amps channel switching jack)
When the pedal is ON
(amps channel switching jack)
4
When you have finished with the editing, press [EXIT].
The top screen appears.
5
After making the changes, follow the instructions in "Storing Controller
Numbers Assigned to the Pedals (Pedal Settings)" (p. 26) to save the settings.
AMP CONTROL
2 jack
Guitar Amp
(AMP CONTROL jack)
Guitar Amp
(AMP CONTROL jack)
Closed
FC-300
Open
FC-300
Control Change Mode
The Range parameter is
enabled when CC#, P.BEND,
or CH.PRS is selected for the
expression pedal.
The Mode parameter and AMP
Ctl Op parameter are enabled
when a control pedal or other
switch function is selected.
The settings made for the
pedals are lost when the pedal
settings are switched. To save
settings made for the pedals,
save them as pedal settings.
For more detailed information,
see "Storing Controller
Numbers Assigned to the
Pedals (Pedal Settings)" (p.
26).
You can change the polarity of
the AMP CONTROL jacks. For
more detailed information, see
"Setting the Polarity of the
AMP CONTROL Jacks" (p.
50).
25