Roland FC-300 Owner's Manual page 35

When Setting Channel Messages and Realtime Messages
1
Press PARAMETER [
MIDI Message
Message Number
2
Press VALUE [
MIDI Message
PC
CC
N.ON
N.OFF
C.PRS
K.PRS
P.BEND
REALTIME
3
Press PARAMETER [
to change.
4
Press VALUE [
If there is any other message you want to change, select the message number as
instructed in Step 4 of "Editing MIDI Streams" (p. 34), then repeat Steps 1-4.
5
After making the changes, follow the instructions in "Storing (Saving)
Patches" (p. 44) to save the MIDI messages to a patch.
] [ ] to move the cursor to the MIDI message.
MIDI Channel
Data
] [ ] to select the MIDI message to be edited.
Data
MIDI Channel (CH#), Program Number (PC#)
MIDI Channel (CH#), Controller Number (CC#), Value (VAL)
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
MIDI Channel (CH#), VALUE
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
MIDI Channel (CH#), Value (MSB, LSB)
MIDI START/MIDI STOP/MIDI CONTINUE
] [ ] to move the cursor to the parameter you want
] [ ] to change the value.
Patch Mode
When the MIDI channel is set
to Tx, the channel set with the
MIDI:Tx Channel parameter in
Utilities is set (p. 52).
35